Updating garmin 430 gps
This output only provides VOR/ILS information on the indicator not GPS deviation information. Since the Garmin GPS 400 is the GPS only version of the GNS 430 GPS/Nav/Comm, it only contains the annunciators for message, waypoint, Auto (GPS AUTO mode of operation), OBS (GPS OBS mode of operation), terminal, approach, and integrity (for position error).Since the GPS 400 does not contain the VOR/LOC/Glideslope portion of the GNS-430, the CDI source select button is omitted as well as the VLOC/GPS annunciator.The GNS-430 outputs 2x5, BCD or slip parallel DME and King Serial DME channeling formats.There is a setup page in the GNS-430 where you can select which DME you will be channeling with the GNS-430.GI-102 (no longer available), Garmin GI-102A, GI-106 (no longer available), GI-106A, S-Tec ST-180 HSI, King KI-202, KI-206, KI-208A, KI-209A, KI-525A, KPI-552, KPI-552B, KPI-553, KPI-553A, KPI-553B, Collins 331A-3G HSI, 331A-9G HSI, 331A-6P HSI, Bendix IN-831A, Century NSD-360, NSD-360A , NSD-1000 HSI, Sperry/Honeywell RD-550A, 650 HSI.The following indicators are compatible as well but not mentioned in the installation manual: King KNI-520, Collins/STec IND-350, IND-350A, IND-351, IND-351A, 331H-3G Basically, a non-converter type indicator is required for the VOR/ILS/GPS Indicator interface to the GNS-430/530 Note: The following indicators may be interfaced to the secondary VOR/ILS output of the GNS-430/530 (Connector P4006).You can monitor standby communications frequencies or navigation facilities while tuned to a primary frequency or facility.According to the Installation Manual, the following indicators are compatible with main switchable VOR/ILS/GPS Indicator output (Connector P4001) for the Garmin GNS-430 and GNS-530 GPS/Nav/Comms.
The KPI-553A uses King Serial Data/Clock for its distance information format.
Due to the variation in condition of units, repair costs can vary significantly.